Manual Shaft Lever Component Installation Note

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Align the mark of the manual shaft lever component as shown. See Fig 1.

Fig 1: Aligning Mark Of Manual Shaft Lever
Courtesy of MAZDA MOTORS CORP.
Install the manual shaft lever component installation nut.
Tightening torque

10.8-14.7 N.m {1.1-1.4 kgf.m, 8.0-10.8 ft.lb}