LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Controls - On-Vehicle Adjustments) >> Closed Throttle Position Switch >> MILLENIA 2.3L >> Inspection

MILLENIA 2.3L: Inspection

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch off. Ensure throttle valve is at Closed Throttle Position (CTP). Disconnect TP sensor 4-pin harness connector. Check for continuity between terminals "C" and "D" of TP sensor connector. See Figure . Continuity should be present. If continuity is present, go to next step. If continuity is not present, adjust TP sensor.
  2. Insert a feeler gauge of specified thickness between throttle lever and throttle stop screw. Check for continuity between terminals "C" and "D" of TP sensor connector. See Figure . Continuity should not be present. If continuity is present, adjust TP sensor.
scientia non olet · About LEMON Manuals