MILLENIA 2.3L: Adjustment

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch off. Ensure throttle valve is at CTP. Disconnect TP sensor connector. Connect ohmmeter between CTP switch terminals "C" and "D" of TP sensor connector. See Fig 1 . Insert a feeler gauge of specified thickness between throttle lever and Throttle Adjusting Screw (TAS). See TP SENSOR CONTINUITY (MILLENIA 2.3L) table.
Loosen TP sensor screws. Rotate TP sensor until ohmmeter indicates continuity as specified. See TP SENSOR CONTINUITY (MILLENIA 2.3L) table. Tighten TP sensor screws. Recheck TP sensor adjustment. If CTP switch cannot be adjusted within specification, replace TP sensor.

Fig 1: Identifying TP Sensor Connector Terminals (Millenia 2.3L)

Courtesy of MAZDA MOTORS CORP.

TP SENSOR CONTINUITY (MILLENIA 2.3L)

Test Condition ⁽¹⁾

Continuity Between Terminals "C" & "D"

.008" (.19 mm)

Yes

.015" (.37 mm)

⁽¹⁾	Insert feeler gauge of specified thickness between throttle lever and throttle stop screw.