LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Engine Mechanical (Service Information)) >> Hydraulic Lash Adjuster (HLA) Removal/Installation >> Notes

Hydraulic Lash Adjuster (HLA) Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the splash shield (RH).
  3. Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  4. Remove the drive belt. (See DRIVE BELT REPLACEMENT .)
  5. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION .)
  6. Remove the water pump drive belt. (See WATER PUMP DRIVE BELT .)
  7. Remove the water pump drive belt pulley. (See WATER PUMP DRIVE BELT PULLEY REMOVAL NOTE .) (See WATER PUMP DRIVE BELT PULLEY INSTALLATION NOTE .)
  8. Remove the camshaft oil seal. (See CAMSHAFT OIL SEAL NOTE .) (See CAMSHAFT OIL SEAL INSTALLATION Note .)
  9. Remove the camshaft oil seal housing.
  10. Remove in the order indicated in the figure.
    Fig 1: Removing/Installing Hydraulic Lash Adjuster
    G00993552Courtesy of MAZDA MOTORS CORP.
  11. Install in the reverse order or removal.
scientia non olet · About LEMON Manuals