Evaporative Emission (EVAP) System Leak Detection Pump Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the fuel tank side of EVAP control system component. (See EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM COMPONENT REMOVAL/INSTALLATION .)
Remove in the order indicated in the illustration.

Fig 1: Evaporative Emission (EVAP) System Leak Detection Pump Removing/Installing Sequence
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.

Fig 2: Removing/Installing Evaporative Emission (EVAP) System Leak Detection Pump
Courtesy of MAZDA MOTORS CORP.