LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Automatic Transaxle [Service, Removal & Installation FN4A-El)) >> Mechanical System Test >> Stall Test

Stall Test

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform mechanical system test preparation. (See Mechanical System Test Preparation .)
  2. Start the engine and shift the selector lever to R position.
    CAUTION:
    • Do not maintain WOT in any position/range for more than 5 seconds, or transaxle damage will occur.
  3. Firmly depress the brake pedal with the left foot, and depress the accelerator pedal to floor (WOT) with the right.
  4. When the engine speed no longer increases, quickly read the engine speed and release the accelerator pedal.
  5. Shift the selector lever to N position and let the engine idle for 1 minute  or more to cool the ATF.
  6. Perform stall tests of D, M (1GR, 2GR) ranges in the same manner.
  7. Turn off the engine.
Fig 1: Engine Stall Speed Specification
G01011855Courtesy of MAZDA MOTORS CORP.
Fig 2: Evaluating Stall Test
G01011856Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals