Rear Washer Motor Inspection [5HB, WGN]

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the front bumper.
Connect battery positive voltage to the motor terminal B and ground to the motor terminal A.
Verify that the rear washer motor operates.

If the motor does not operate, replace the rear washer motor.

Fig 1: Identifying Rear Washer Motor Terminals - 5HB, WGN
Courtesy of MAZDA MOTORS CORP.