LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Washer System & Wiper System) >> Rear Washer Hose Removal/Installation [5HB, WGN]

Rear Washer Hose Removal/Installation [5HB, WGN]

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION [5HB, WGN] )
  3. Partially peel off the right side mud guard.
  4. Remove rear washer hose No. 1 from the clips.
  5. Remove rear washer hose No. 1 and joint pipe A.
  6. Remove the A-pillar trim.
    Fig 1: Locating Rear Washer Hose No. 1 Clips - 5HB, WGN
    G01023128Courtesy of MAZDA MOTORS CORP.
  7. Remove rear washer hose No. 2 from clip A.
    Fig 2: Locating Rear Washer Hose No. 2 Clips - 5HB, WGN
    G01023129Courtesy of MAZDA MOTORS CORP.
  8. Remove clips B from the body.
  9. Remove rear washer hose No. 2 and joint pipes B.
  10. Remove the C-pillar trim.
  11. Remove the D-pillar trim. (WGN)
  12. Remove the liftgate upper trim.
  13. Remove rear washer hose No. 3 from clip C.
    Fig 3: Locating Rear Washer Hose No. 3 Clips - 5HB, WGN
    G01023130Courtesy of MAZDA MOTORS CORP.
  14. Remove clips D from the body. (5HB)
  15. Remove rear washer hose No. 3 and joint pipe C.
  16. Remove the headliner.
  17. Remove the tape from rear washer hose No. 4.
  18. Install in the reverse order of removal.
    Fig 4: Locating Rear Washer Hose No. 4 Clips - 5HB, WGN
    G01023131Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals