Variable Air Duct (VAD) Control Solenoid Valve Inspection: Notes

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
Inspect airflow between the ports under the following conditions.
- If not as specified, replace the VAD control solenoid valve.
- If as specified, carry out the CIRCUIT OPEN/SHORT INSPECTION .
  
  Fig 1: Inspecting Continuity And Airflow
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Locating VAD Control Solenoid Valve Connector
  Courtesy of MAZDA MOTORS CORP.