LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (On-Board Diagnostic [Engine Control System AJ)) >> OBD-II Drive Mode >> Mode 3 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (Cal: Except For AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T))

Mode 3 (H02S Heater, H02S & TWC Repair Verification Drive Mode) (Cal: Except For AJ57EM060AJV5010 (M/T), AJ58EM060AJVN010 (A/T))

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform "PCM Adaptive Memory Production Drive Mode" first.
  2. Verify all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  3. Drive the vehicle as shown in the graph. The driving conditions before driving at constant speed are not specified.
    Fig 1: Vehicle Drive Graph (Mode 3)
    G01024723Courtesy of MAZDA MOTORS CORP.
  4. Stop the vehicle and access the ON BOARD SYSTEM READINESS menu of GENERIC OBD-II FUNCTION to verify the OBD monitoring status.
    • If completed, the OBD monitoring status items change from non-completed to completed.
    • If not completed, turn the ignition switch off, then repeat from Step  3.
  5. Access the DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD-II FUNCTIONS to verify the monitor results.
    • If the detected values are not within the specification, the repair has not been completed.
  6. Verify no DTCs are available.
scientia non olet · About LEMON Manuals