LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Engine Mechanical (Service Information L3)) >> Timing Chain Removal/Installation >> Crankshaft Pulley Lock Bolt Removal Note

Crankshaft Pulley Lock Bolt Removal Note

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cylinder block lower blind plug.
  2. Install the SST. 
    Fig 1: Installing Special Service Tool In Place Of Cylinder Block Lower Blind Plug
    G01024997Courtesy of MAZDA MOTORS CORP.
  3. Rotate the crankshaft clockwise until the crankshaft is in the No.1 cylinder TDC position (until the balance weight is contacting to the SST  ).
  4. Hold the crankshaft pulley using the SSTs. 
Fig 2: Holding Crankshaft Pulley
G01024998Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals