Resistance Inspection: Notes

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the following procedure only when directed.

Disconnect the negative battery cable.
Inspect resistance of the EVAP system leak detection pump.
- If not as specified, replace the EVAP system leak detection pump.
- If as specified, carry out the "Circuit Open/Short Inspection".

Fig 1: Evaporative Emission System Leak Detection Pump Terminals Resistance Specification Table

Courtesy of MAZDA MOTORS CORP.