4X2 Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
1. Using the special tool, install new seals on the power steering return hose and power steering pressure hose.
  
  Fig 1: Installing Seals
  Courtesy of MAZDA MOTORS CORP.
2. If necessary, remove the tie-rod ends.
3. The dished side of the washer faces downward.
4. Install a new intermediate shaft pinch bolt.
Fill, purge, and leak check the power steering system.
Check and if necessary, adjust the wheel alignment.