Removal & Installation

WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the unlock position.
Remove the tire and wheel assembly. Refer to WHEELS AND TIRES .
Remove the castellated nut.
1. Remove the cotter pin.
2. Remove the castellated nut.
  
  Fig 1: Removing Castellated Nut
  Courtesy of MAZDA MOTORS CORP.
Loosen the tie rod end jam nut.

Fig 2: Loosening Tie Rod End Jam Nut
Courtesy of MAZDA MOTORS CORP.
Using the special tool, separate the tie rod end.

Fig 3: Separating Tie Rod End
Courtesy of MAZDA MOTORS CORP.
Remove the tie rod end.

Fig 4: Removing Tie Rod End
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.
1. Adjust the front toe. Refer to SPECIFICATIONS .