Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2003 Mazda Tribute and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the upper intake manifold. Refer to the following:
- For 2001 models, see UPPER INTAKE MANIFOLD .
- For 2002 models, see UPPER INTAKE MANIFOLD .
- For 2003 models, see UPPER INTAKE MANIFOLD .
Remove the RH coil-on-plugs.
1. Disconnect the three electrical connectors.
2. Remove the three bolts.
3. Remove the RH coil-on-plugs.
  
  Fig 1: Removing RH Coil-On-Plugs
  Courtesy of MAZDA MOTORS CORP.
Remove the wiring harness nuts and disconnect the (O2) sensor electrical connectors.

Fig 2: Removing Wiring Harness Nuts & Disconnecting (O2) Sensor Electrical Connectors
Courtesy of MAZDA MOTORS CORP.
Disconnect the radio ignition interference capacitor.

Fig 3: Disconnecting Radio Ignition Interference Capacitor
Courtesy of MAZDA MOTORS CORP.
Separate the harness from the center locating pins and position aside.

Fig 4: Separating Harness From Center Locating Pins
Courtesy of MAZDA MOTORS CORP.
Disconnect the crankcase ventilation tube from the valve cover.

Fig 5: Disconnecting Crankcase Ventilation Tube
Courtesy of MAZDA MOTORS CORP.
Remove the bolts, studs and the RH valve cover.
- Remove and discard the gasket.
Fig 6: Removing RH Valve Cover
Courtesy of MAZDA MOTORS CORP.