Removal & Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle.
Remove and discard the nuts.
1. Discard the gasket.
Fig 1: Removing Nuts
Courtesy of MAZDA MOTORS CORP.
Disconnect the resonator from the hanger and remove the resonator.

Fig 2: Removing Resonator
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.
- Install a new gasket.
- Install new nuts.