Removal & Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle.
Remove the splash shield.

Fig 1: Removing Splash Shield
Courtesy of MAZDA MOTORS CORP.

NOTE: The A/C compressor has been removed for clarity.

Fig 2: Removing Oil Pressure Sender

Courtesy of MAZDA MOTORS CORP.

Remove the oil pressure sender.
1. Disconnect the electrical connector.
2. Remove the sender.
To install, reverse the removal procedure.