Exhaust Manifold - LH: Removal

WARNING: This page is about a different car, the 2003 Mazda Tribute and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LH Heated Oxygen Sensor (HO2S) and the LH catalyst monitor. Refer to the following:
- For 2001 models, see HEATED OXYGEN SENSOR .
- For 2002 models, see HEATED OXYGEN SENSOR .
- For 2003 models, see HEATED OXYGEN SENSOR .
Remove the bolts and the splash shield.

Fig 1: Removing Splash Shield
Courtesy of MAZDA MOTORS CORP.
Remove the exhaust crossover and position aside.

Fig 2: Removing Exhaust Crossover
Courtesy of MAZDA MOTORS CORP.
Remove the accessory drive belt. Refer to the following:
- For 2001 models, see BELT ROUTING .
- For 2002 models, see BELT ROUTING .
- For 2003 models, see DRIVE BELT ROUTING .
Remove the A/C compressor bolts and position aside.

Fig 3: Removing A/C Compressor
Courtesy of MAZDA MOTORS CORP.
Remove the nuts and LH exhaust manifold and discard the gasket.

Fig 4: Removing LH Exhaust Manifold
Courtesy of MAZDA MOTORS CORP.