LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Air Bag System) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicle) (Seats Installed) >> Driver-side AIR Bag (Seats Installed)

Driver-side AIR Bag (Seats Installed)

WARNING: This page is about a different car, the 2004 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before deploying air bag, inspect operating condition of Deployment Tool (49 H066 002). See INSPECTING DEPLOYMENT TOOL  . Ensure vehicle is outside and away from other vehicles and people. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove steering wheel access plug and disconnect driver-side air bag module connector. Connect deployment tool connector "A" to driver-side air bag module connector. See Figure . Close all doors and windows. Connect Red clip of deployment tool to positive battery terminal and Black clip of deployment tool to negative battery terminal. Verify deployment tool Red light is on.
  3. Ensure all persons are at least 20 feet (6 m) from vehicle. Press deployment tool activation switch to deploy air bag. Because of heat generated from air bag deployment, wait at least 15 minutes before handling deployed air bag module.
scientia non olet · About LEMON Manuals