Removal and Installation

WARNING: This page is about a different car, the 2004 Mazda Tribute, 2003 Mazda Tribute, and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear quarter trim panel.
Remove the upper shock absorber nut.

Fig 1: Identifying Upper Shock Absorber Nut
Courtesy of MAZDA MOTORS CORP.
Raise and support the vehicle enough to relax the suspension system.
Remove the shock absorber.
- Remove the lower shock absorber nut.
  
  Fig 2: Identifying Lower Shock Absorber Bolt
  Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.