Upper Arm Installation - 4x2

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Mazda B4000, 2004 Mazda B3000, 2004 Mazda B2300, 2003 Mazda B4000, and 2003 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

Align the marks made during removal on the front suspension upper arm adjustment cam.
NOTE: The forward front suspension upper arm nut must be tightened first while the arm is held at the curb position ride height.

Fig 1: Aligning Upper Arm Adjustment Cam Marks
Courtesy of MAZDA MOTORS CORP.
Install the front suspension upper arm.
1. Position the front suspension upper arm.
2. Install the two bolts and nuts.
Fig 2: Installing Front Suspension Upper Arm
Courtesy of MAZDA MOTORS CORP.
Install the upper ball joint into the front wheel spindle.
1. Position the upper ball joint in the front wheel spindle.
2. Install the pinch bolt and nut.
Fig 3: Installing Pinch Bolt & Nut
Courtesy of MAZDA MOTORS CORP.
Remove the front disc brake rotor shield. See FRONT BRAKE ROTOR REMOVAL & INSTALLATION.
Install the tire and wheel assembly.
Inspect and adjust the front end alignment. See WHEEL ALIGNMENT SPECIFICATIONS .