LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Rear Suspension System) >> General Procedures >> Rear CROSSMEMBER >> Rear Crossmember Removal/Installation >> No. 3 Bushing Removal Note

No. 3 Bushing Removal Note

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark the rear crossmember with the bushing hole aligned as shown in the illustration.
    Fig 1: Marking Crossmember For No. 3 Bushing Install
    G00379526Courtesy of MAZDA MOTORS CORP.
  2. Remove the bushing using the SST. See Figure.
scientia non olet · About LEMON Manuals