LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Fwd Axle Shafts) >> Overhaul >> Intermediate Shaft (3.0L) >> Reassembly >> Dust Seal (Differential Side) Assembly Note

Dust Seal (Differential Side) Assembly Note

WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply grease to the new dust seal lip.
  2. Install the new differential side dust seal using a press, steel plate and the Bearing Installer (49-W027-003). See Fig 1 .
    CAUTION: Do not damage the rubber part of the dust cover.
Fig 1: Assembling Differential Side Dust Seal
G00318698Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals