EGR Vent Solenoid Valve - Millenia
WARNING: This page is about a different car, the 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, 2001 Mazda MPV, and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
Remove EGR vent solenoid valve. See EGR VACUUM/VENT SOLENOID VALVE LOCATIONS table. Apply air pressure to port "A". See Fig 1 . Air should flow from ports "B" and "C". Using fused jumper wires, apply battery voltage to solenoid valve terminals. Apply air pressure to port "A". Air should flow from port "B" only. Replace solenoid valve as necessary.
EGR VACUUM/VENT SOLENOID VALVE LOCATIONS
| Application | Location | |
|---|---|---|
| Millenia | Right Rear Of Engine Compartment | |
| 626 | ||
| 2.0L | Right Side Of Engine | |
| 2.5L | Center Rear Of Engine Compartment | |