Diagnostic Procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED Have the FREEZE FRAME DATA (Mode 2)/snapshot data and DIAGNOSTIC MONITORING TEST RESULTS (EVAP system related) been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA (Mode 2)/snapshot data and DIAGNOSTIC MONITORING TEST RESULTS on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY RELATED PENDING CODE AND/OR DTC Switch the ignition to off, then to ON (engine off). Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Is the PENDING CODE/DTC P0451:00, P0452:00, P0453:00 or P0454:00 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC P0451:00 .) (See DTC P0452:00 .) (See DTC P0453:00 .) (See DTC P0454:00 .)
3		No	Go to the next step.
4	INSPECT FOR BLOCKED FUEL VAPOR TUBE BETWEEN FUEL TANK PRESSURE SENSOR AND FUEL TANK Switch the ignition to off. Remove the fuel vapor tube assembly. (See FUEL TANK REMOVAL/INSTALLATION .) Visually inspect the fuel vapor tube for a blockage between fuel tank pressure sensor and connection to the fuel tank. Visually inspect the connection at the fuel tank for a blockage. Attempt to manually remove the blockage. Is the blockage visible and can be removed?	Yes	Remove the blockage, then go to the next step.
4		No	Replace the fuel vapor tube assembly, then go to the next step.
5	VERIFY DTC TROUBLESHOOTING COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE .) Perform the Drive Mode 06 (EVAP System Repair Verification Drive Mode). (See OBD-II DRIVE MODE .) Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
5		No	Go to the next step.
6	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
6		No	DTC troubleshooting completed.