Rear Oil Seal Assembly Note
- Apply clean engine oil to the new oil seal lip.
- Install the SST to the non-woven fabric side of the rear oil seal.
- From the back side of the rear oil seal, verify that there is no damage or separation in the lip area of the rear oil seal.
- Install the rear oil seal to the engine.
- Tighten the rear oil seal bolts in the order as shown in the figure. (Except TRIBUTE (L.H.D.) Face-lifted model.)
Tightening torque
8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}