Rear Oil Seal Installation Note

Apply silicone sealant to the mating faces as shown in the figure.
CAUTION:
- Install the rear oil seal before the applied silicone sealant starts to harden.
Fig 1: Identifying Silicone Sealant Application Area On Mating Faces

Thickness
- 2.2-3.2 mm {0.09-0.12 in}
Apply clean engine oil to the new oil seal lip.
Install the SST to the non-woven fabric side of the rear oil seal.

Fig 2: Installing SST To Non-Woven Fabric Side Of Rear Oil Seal
From the back side of the rear oil seal, verify that there is no damage or separation in the lip area of the rear oil seal.

Fig 3: Identifying Lip Area Of Rear Oil Seal
Install the rear oil seal to the engine as shown in the figure.

Fig 4: Installing Rear Oil Seal To Engine
Tighten the rear oil seal bolts in the order as shown in the figure.

Fig 5: Identifying Rear Oil Seal Bolt Tightening Sequence

Tightening torque
- 8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}