Diagnostic Procedure

STEP	INSPECTION		ACTION
1	PERFORM DSC HU/CM DTC INSPECTION Perform the DSC HU/CM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
1		No	Go to the next step.
2	PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS DSC HU/CM Clear the DTC using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition to ON and wait for 20 s or more . Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
2		No	Go to Step 4.
3	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition to ON and wait for 20 s or more . Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .)
4		No	DTC troubleshooting completed.