| DESCRIPTION |
- U0001:88
- CAN system communication error (HS-CAN)
- U0010:88
- CAN system communication error (MS-CAN)
- U0100:00
- Communication error to PCM
- U0101:00
- Communication error to TCM
- U0121:00
- Communication error to DSC HU/CM
- U0131:00
- Communication error to EHPAS control module
- U0140:00
- Communication error to BCM
- U0151:00
- Communication error to SAS control module
- U0156:00
- Communication error to information display
- U0164:00
- Communication error to climate control unit
|
| DETECTION CONDITION |
- U0001:88
- Instrument cluster detects the malfunction in the CAN bus communication line (HS-CAN).
- U0010:88
- Instrument cluster detects the malfunction in the CAN bus communication line (MS-CAN).
- U0100:00
- Instrument cluster cannot receive the signal from PCM for 1 s or more
when the ignition is switched to ON.
- U0101:00
- Instrument cluster cannot receive the signal from TCM for 1 s or more
when the ignition is switched to ON.
- U0121:00
- Instrument cluster cannot receive the signal from DSC HU/CM for 1 s or more
when the ignition is switched to ON.
- U0131:00
- Instrument cluster cannot receive the signal from EHPAS control module for 1 s or more
when the ignition is switched to ON.
- U0140:00
- Instrument cluster cannot receive the signal from BCM for 5 s or more
when the ignition is switched to ON.
- U0151:00
- Instrument cluster cannot receive the signal from SAS control module for 2 s or more
when the ignition is switched to ON.
- U0156:00
- Instrument cluster cannot receive the signal from information display for 5 s or more
under the following conditions:
- Ignition switch: ON
- Engine speed: 500 rpm or more
- U0164:00
- Instrument cluster cannot receive the signal from climate control unit for 5 s or more
under the following conditions:
- Ignition switch: ON
- Engine speed: 500 rpm or more
|
| FAIL-SAFE FUNCTION |
- U0001:88, U0010:88, U0100:00, U0101:00, U0121:00, U0131:00, U0151:00, U0156:00, U0164:00
- U0140:00
- Turn off the fog lights.
- Turn off the headlight high beam.
|
| POSSIBLE CAUSE |
- Malfunction in CAN bus communication line
- Malfunction in CAN line between instrument cluster and PCM
- Malfunction in CAN line between instrument cluster and TCM
- Malfunction in CAN line between instrument cluster and DSC HU/CM
- Malfunction in CAN line between instrument cluster and EHPAS control module
- Malfunction in CAN line between instrument cluster and BCM
- Malfunction in CAN line between instrument cluster and SAS control module
- Malfunction in CAN line between instrument cluster and information display
- Malfunction in CAN line between instrument cluster and climate control unit
|
| SYSTEM WIRING DIAGRAM |
- |