DTC U2100:00/U2101:00 [Dynamic Stability Control (DSC)]: Notes

DTC	U2100:00, U2101:00	Configuration data not recorded
DETECTION CONDITION	U2100:00 (configuration not implement) After switch the ignition to ON, DSC HU/CM detects that configuration is not implement U2101:00 (configuration data error) After switch the ignition to ON, DSC HU/CM checks central configuration data which instrument cluster sends to CAN, and any of the following conditions is detected Data sent from instrument cluster exceeds specification Data sent from instrument cluster is within specification, however, the data and data stored in DSC HU/CM are incompatible
FAIL-SAFE FUNCTION	Illuminates the TCS/DSC indicator light. Inhibits the TCS, DSC and brake assist controls.
POSSIBLE CAUSE	Module configuration procedure is not done properly Correct data cannot be received from instrument cluster
SYSTEM WIRING DIAGRAM	-