Diagnostic Procedure

STEP	INSPECTION		ACTION
1	RECORD THE CAR CONFIGURATION DATA Switch the ignition to off. Switch the ignition to ON, and maintain this condition for approx. 30 s .		Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, go to the next step.
2		No	Go to Step 5.
3	INSPECT FOR INSTRUMENT CLUSTER MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the instrument cluster. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) After repairing the instrument cluster, perform the "INSTRUMENT CLUSTER CONFIGURATION", then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION .)
3		No	Go to the next step.
4	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1.
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
5		No	DTC troubleshooting completed.