Diagnostic Procedure
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | PERFORM BCM DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [BCM] .) |
| No | Go to the next step. | ||
| 2 | VERIFY THAT THE SAME DTC IS NOT PRESENT
|
Yes | Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY THAT NO OTHER DTCS ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) |
| No | DTC troubleshooting completed. | ||