Diagnostic Procedure

STEP	INSPECTION		ACTION
1	VERIFY NO DSC HU/CM MALFUNCTION Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Start the engine and drive the vehicle at 10km/h {6.2 mph} or more . Are the same DTCs present?	Yes	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
1		No	Go to the next step.
2	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
2		No	DTC troubleshooting completed.