Double-sided Adhesive Tape Installation Note

When installing a new rear spoiler, perform the following procedure:
1. Remove the double-sided adhesive tape on the liftgate.
2. Remove any grease or dirt from the affixing surface of the liftgate.
If the rear spoiler is to be reused, perform the following procedure:
1. Remove the double-sided adhesive tape remaining on the rear spoiler and liftgate after removal.
2. Remove any grease and dirt from the double-sided adhesive tape affixing area.
3. Affix double-sided adhesive tape to the position shown in the figure.
  
  Fig 1: Identifying Double-Sided Adhesive Tape Application Position On Rear Spoiler
  NOTE:
  - Use the 3M GT7130-type of double-sided adhesive tape, or the equivalent.