Diagnostic Procedure
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY RELATED DTCs
|
Yes | Go to the applicable DTC inspection. (See SECURITY INDICATOR LIGHT: -, DTC: U0001:88/U0073:00 [IMMOBILIZER SYSTEM] .) |
| No | Go to the next step. | ||
| 2 | VERIFY WHETHER PROGRAMMING OF IMMOBILIZER SYSTEM-RELATED PARTS HAS BEEN PERFORMED AFTER INSTRUMENT CLUSTER REPLACEMENT
|
Yes | Go to the next step. |
| No | Perform the programming of immobilizer system-related parts after replacing the instrument cluster only, then go to Step 5. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING .) |
||
| 3 | VERIFY WHETHER PROGRAMMING OF IMMOBILIZER SYSTEM-RELATED PARTS HAS BEEN PERFORMED AFTER PCM REPLACEMENT
|
Yes | Go to the next step. |
| No | Perform the programming of immobilizer system-related parts after replacing the PCM only, then go to Step 5. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING .) |
||
| 4 | PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS INSTRUMENT CLUSTER
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to Step 6. | ||
| 5 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Repeat the inspection from Step 1.
|
| No | Go to the next step. | ||
| 6 | VERIFY THAT NO OTHER DTCs ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [IMMOBILIZER SYSTEM] .) |
| No | DTC troubleshooting completed. | ||