Security Indicator Light
- Switch the ignition to ON.
- Verify the security indicator light status.
- If a malfunction is detected, the DTC pattern begins flashing after the security indicator light flashes or illuminates for approx. 1 min
according to the DTC. However, because there are DTCs which cannot be confirmed using the security indicator light, verify the DTCs that were detected using the M-MDS prior to beginning the servicing.
- DTC 16 or below: Flashes for approx. 1 min
and the DTC flash pattern repeats 10 times
.
- DTC 21 or higher: Illuminates for approx. 1 min
and the DTC flash pattern repeats 10 times
.
- If more than one DTC is detected, only the DTC with the lowest number is displayed.
- If there is no malfunction, the security indicator light illuminates for approx. 3 s
, and then turns off.
- If there is a malfunction, verify the DTCs using the M-MDS. When several DTCs are detected, repair the malfunctioning location based on the DTC displayed by the security indicator light. (See DTC TABLE [IMMOBILIZER SYSTEM] .)
NOTE:
- Because of the possibility that one malfunction cause could result in several DTCs being detected, erase the DTCs after the repair is completed, and then re-inspect the DTCs.
- After completion of repairs, clear all DTCs stored in the instrument cluster and PCM. (See CLEARING DTC [IMMOBILIZER SYSTEM] .)