CMDTC self test
- Connect the M-MDS (IDS) to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Self Test".
- Select "All CMDTCs".
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. When several DTCs are detected, repair the malfunctioning location based on the DTC displayed by the security indicator light. (See DTC TABLE [IMMOBILIZER SYSTEM] .)
NOTE:
- Because of the possibility that one malfunction cause could result in several DTCs being detected, erase the DTCs after the repair is completed, and then check for DTCs again.
- After completion of repairs, clear all DTCs stored in the instrument cluster and PCM. (See CLEARING DTC [IMMOBILIZER SYSTEM] .)