LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Lighting System >> Hazard Warning Switch Inspection

Hazard Warning Switch Inspection

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
    2. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
    3. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION .)
  3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table.
    Fig 1: Identifying Hazard Warning Switch Terminals
    G08153357
    • If not as indicated in the table, replace the hazard warning switch.
    Fig 2: Hazard Warning Switch Terminals Continuity Chart
    G08153358
  4. Apply battery voltage to hazard switch terminal A, and connect terminal F to ground.
  5. Verify that the LED illuminates.
    • If there is any malfunction, replace the hazard warning switch.
scientia non olet · About LEMON Manuals