Diagnostic Procedure

Step	Inspection		Action
1	INSPECT STEERING SWITCH CONNECTOR CONDITION Switch the ignition OFF (LOCK). Disconnect the negative battery cable. Disconnect the steering switch connector. Inspect the connector for poor connection (such as damaged/pulled-out pins, and corrosion). Is there any malfunction?	Yes	Repair or replace the connector or terminal, then go to Step 7.
1		No	Go to the next step.
2	INSPECT CLOCK SPRING CONNECTOR CONDITION Disconnect the clock spring connector. Inspect the connector for poor connection (such as damaged/pulled-out pins, and corrosion). Is there any malfunction?	Yes	Repair or replace the connector or terminal, then go to Step 7.
2		No	Go to the next step.
3	INSPECT Bluetooth UNIT CONNECTOR CONDITION Disconnect the Bluetooth unit connector. Inspect the connector for poor connection (such as damaged/pulled-out pins, and corrosion). Is there any malfunction?	Yes	Repair or replace the connector or terminal, then go to Step 7.
3		No	Go to the next step.
4	INSPECT STEERING SWITCH Inspect the steering switch. (See STEERING SWITCH INSPECTION .) Is there any malfunction?	Yes	Replace the steering switch, then go to Step 7. (See STEERING SWITCH REMOVAL/INSTALLATION .)
4		No	Go to the next step.
5	INSPECT CLOCK SPRING Inspect the crock spring. (See CLOCK SPRING INSPECTION .) Is there any malfunction?	Yes	Replace the crock spring, then go to Step 7. (See CLOCK SPRING REMOVAL/INSTALLATION .)
5		No	Go to the next step.
6	INSPECT STEERING SWITCH INPUT CIRCUIT FOR SHORT TO GROUND Make sure reconnect the disconnected connectors. Inspect for continuity between the following terminals (wiring harness-side) and body ground: Bluetooth unit terminal F Is there continuity?	Yes	Repair or replace the wiring harness for a possible short to ground, then go to the next step.
6		No	Go to the next step.
7	VERIFY TROUBLESHOOTING COMPLETED Switch the ignition OFF (LOCK). Reconnect the negative battery cable. Clear the DTC from the Bluetooth unit memory. (See CLEARING DTC [BLUETOOTH SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)] .) Perform the Bluetooth unit DTC inspection. (See DTC INSPECTION [BLUETOOTH SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)] .) Is the same DTC present?	Yes	Replace the Bluetooth unit, then go to the next step. (See BLUETOOTH UNIT REMOVAL/INSTALLATION .)
7		No	Go to the next step.
8	VERIFY THAT NO OTHER DTCs ARE RECORDED Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [BLUETOOTH SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)] .)
8		No	DTC troubleshooting completed.