Rear Crankshaft Main Bearing Seal: Service and Repair

REAR OIL SEAL REPLACEMENT [MZI-3.7]

1. Remove the automatic transaxle. Automatic Transaxle Removal/Installation

2. Remove the drive plate. Service and Repair

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.










Rear Oil Seal Removal Note

1. Using a flathead screwdriver, remove the rear oil seal.






Rear Oil Seal Installation Note

NOTE:
- Lubricate the rear oil seal lips and bore with clean engine oil.

1. Push the rear oil seal slightly in by hand.

2. Tap the rear oil seal in evenly using the SST and a hammer.






Substitution SST
- 49 W011 101
Outer diameter: 105 mm {4.13 in} or more
Inner diameter: 93-105 mm {3.7-4.1 in}
Tube with board thickness 2 mm {0.079 in} or more