| POSSIBLE CAUSE |
- Instrument cluster and DSC HU/CM configuration data do not coincide
- Instrument cluster configuration incomplete or in error
- BCM malfunction
- DSC HU/CM malfunction
- DSC HU/CM stores DTC
- Brake fluid level sensor malfunction (BCM)
- Parking brake switch malfunction (BCM)
- Instrument cluster malfunction
- Connector or pin malfunction
- Short circuit in wiring harness between CAN-L, CAN-H and ground
- Open circuit in CAN wiring harness (CAN-L, CAN-H)
- CAN wiring harness (CAN-L, CAN-H) short each other
- Malfunction in brake switch signal input to PCM
|