Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP	INSPECTION	RESULTS	ACTION
1	VERIFY PCM DTC Switch the ignition to ON (Engine off). Retrieve any DTCs using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST .) Are there any DTCs displayed?	Yes	DTC is displayed: Go to the appropriate DTC inspection. (See DTC TABLE .)
1		No	No DTC is displayed: Inspect the instrument cluster operation. (See INSTRUMENT CLUSTER INSPECTION .)
2	Verify test results. If normal, return to diagnostic index to service any additional symptoms. (See SYMPTOM DIAGNOSTIC INDEX .) If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis. If vehicle is repaired, troubleshooting completed. If vehicle is not repaired or additional diagnostic information is not available, reprogram the PCM if a later calibration is available. Retest.