LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical [Lubrication System MZI 3.7 V6]) >> Oil Pan Removal/Installation >> Oil Pan Removal Note

Oil Pan Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the cover as shown in the figure.
    Fig 1: Oil Pan Cover
    G00567343Courtesy of MAZDA MOTORS CORP.
  2. Remove the oil pan installation bolts.
  3. Install two of the oil pan bolts temporarily into the two threaded holes in the oil pan.
    Fig 2: Oil Pan Bolts
    G04969500Courtesy of MAZDA MOTORS CORP.
  4. Alternately tighten the two bolts one turn at a time until the oil pan-to-cylinder block seal is released.
  5. Remove the oil pan.
scientia non olet · About LEMON Manuals