Ignition Timing Inspection
WARNING: This page is about a different variant/trim than selected.
- Perform "Engine Tune-up Preparation". (See ENGINE TUNE-UP PREPARATION .)NOTE:
- The ignition timing cannot be adjusted.
- The M-MDS is required to verify the ignition timing.
- Verify that the ignition timing (M-MDS: SPARKADV) is within the specification using M-MDS function.
Ignition timing
- Approx. BTDC 13 °
- Verify that ignition timing advances when the engine speed increases gradually.
- If it is not within the specification, refer to "ENGINE SYMPTOM TROUBLESHOOTING". (See SYMPTOM DIAGNOSTIC INDEX .)