Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related Service Bulletins available?	Yes	Perform repair or diagnosis according to the available Service Bulletins. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT TP SENSOR RESISTANCE Switch the ignition off. Disconnect the throttle body connector. Measure the resistance between the following terminals (throttle body component side). Throttle body terminal F and D: 700-1, 800 ohms Throttle body terminal F and E: 1, 300-2, 800 ohms Throttle body terminal C and D: 1, 000-2, 400 ohms Throttle body terminal C and E: 500-1, 500 ohms Throttle body terminal D and E: 700-2, 100 ohms Are all the resistances within specifications?	Yes	Go to the next step.
3		No	Replace the throttle body, then go to Step 6. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
4	INSPECT TP SENSOR SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY Switch the ignition ON (Engine off). Measure the voltage between the following circuits: Throttle body terminal F (wiring harness-side) and body ground. Throttle body terminal C (wiring harness-side) and body ground. Are there voltage B+ ?	Yes	Repair or replace suspected part, then go to Step 6.
4		No	Go to the next step.
5	INSPECT TP SENSOR SIGNAL CIRCUITS FOR SHORT EACH OTHER Switch the ignition off. Disconnect the throttle body and PCM connector. Measure resistance between throttle body terminal F and C. Is the resistance more than 10 kilohms ?	Yes	Go to the next step.
5		No	Repair or replace suspected part, then go to the next step.
6	VERIFY TROUBLESHOOTING OF DTC P2135:00 HAS BEEN COMPLETED Verify that all disconnected connectors reconnected. Clear the DTC from the PCM memory using the M-MDS. Start the engine. Is the same DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION .) Go to the next step.
6		No	Go to the next step.
7	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
7		No	DTC troubleshooting completed.