DTC P1001:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P1001:00 |
KOER not able to complete, KOER aborted |
| DETECTION CONDITION |
- P1001:00 indicates any of the following
- Unable to access Continuous Memory DTCs.
- Unable to activate KOEO or KOER Self-Test.
- M-MDS tester communication problem.
- DTC displayed by M-MDS tester not listed.
- KOER Self-Test cannot be completed.
|
| POSSIBLE CAUSE |
- Damaged DLC-2.
- Open circuit in DLC-2 wiring harness circuit.
- Short circuit in DLC-2 circuit or related modules.
- Incorrect Self-Test procedure.
- VREF is not within specification.
- Idle RPM out of specification.
- Damaged PCM power relay circuit
- PCM malfunction
|