LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (On-Board Diagnostic [Engine Controls MZI 3.7] (2 Of 5)) >> DTC P0111:00 >> Notes

DTC P0111:00: Notes

WARNING: This page is about a different variant/trim than selected.
DTC P0111:00 IAT sensor circuit range/performance
DETECTION CONDITION 
  • Indicates the IAT rationality test has failed. This DTC indicates that the IAT value is higher than a calibrated value and could prevent 1 or more on-board diagnostic (OBD) monitors from completing. The PCM runs this logic after an engine off and a calibrated soak period (typically 6 hours) This soak period allows IAT and CHT to stabilize and not differ by more than a calibrated value. DTC P0111:00 is set when: the IAT at engine start exceeds the CHT by more than a calibrated value, typically 17 °C {63 °F}.
POSSIBLE CAUSE 
  • IAT sensor malfunction
scientia non olet · About LEMON Manuals