Warm Up Three Way Catalytic Converter (WU-TWC) (LH) Installation Note
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Be sure to follow the procedure below in installing the components. Otherwise improper fastening or seating may occur.
- Temporarily tighten bolt of A.
- Temporarily tighten nut of B.
- Temporarily tighten bolt of C.
- Tighten nut of B with tightening torque.
Tightening torque
- 34-46 N.m {3.5-4.6 kgf.m, 26-33 ft.lbf}
- Tighten bolt of C with tightening torque.
Tightening torque
- 17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}
- Tighten bolt of A with tightening torque.
Tightening torque
- 17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}