Presilencer and Middle Pipe Installation Note

WARNING: This page is about a different variant/trim than selected.

NOTE:

When newly replacing the presilencer or the middle pipe, place alignment marks on the new part in the same position as the removed part.

Install the presilencer to the middle pipe using the following procedure.
1. Align the presilencer and the middle pipe alignment marks.
  
  Fig 1: Aligning Presilencer And Middle Pipe Alignment Marks
2. Tighten the nut shown in the figure.
  
  Fig 2: Identifying Clamp Nut
  
  Tightening torque
  - 41-51 N.m {4.2-5.2 kgf.m, 31-37 ft.lbf}