No.30 Does Not Downshift In M Position: Notes
WARNING: This page is about a different variant/trim than selected.
| 30 |
Does not downshift in M position |
| DESCRIPTION |
- Gear position indicator light in instrument cluster illuminates, but the vehicle does not downshift when the selector lever is pushed to "-" side.
|
| POSSIBLE CAUSE |
- Down switch, M position switch (built-in selector lever component) or related wiring harness malfunction
- Multiplex communication system malfunction (Shift position signal is incorrect.)
- Between TCM and instrument cluster
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|